PDA

View Full Version : Project Winter Beater

Pages : 1 2 3 4 5 6 7 [8] 9 10 11 12 13 14 15 16 17 18 19 20 21 22
123abc
03-13-2010, 06:49 PM
Looking good! You gonna swap valve covers?


I'm going to paint this one. When I got a new vc gasket I'll do it up.
123abc
03-16-2010, 02:56 PM
The rear ss lines are on:

http://www.mitsustyle.com/photopost/data/627/medium/SDC11258.JPG

http://www.mitsustyle.com/photopost/data/627/medium/SDC11257.JPG


The car is mostly waiting on me to sell the old motor so I can pick up a clutch disk and flywheel.
Kevin 1G Drummer
03-16-2010, 03:01 PM
SS lines are awesome. I had them all the way around on my DSM, and soon I'll have them all the way around on the 240.
123abc
03-16-2010, 03:06 PM
SS lines are awesome. I had them all the way around on my DSM, and soon I'll have them all the way around on the 240.

I've never driven a car with them so I'm pretty excited to try them out. This is the first time I actually put a little more than pocket change into the brakes. lol
Kevin 1G Drummer
03-16-2010, 03:08 PM
Brake upgrades is always money well spent. Haha your car can never stop too well.
123abc
03-16-2010, 10:37 PM
So I was bored tonight after work so I went out to the garage and started getting into it again.....

http://www.mitsustyle.com/photopost/data/627/medium/SDC11259.JPG

Here's just the engine harness:

http://www.mitsustyle.com/photopost/data/627/medium/SDC11260.JPG

I'm putting the fender fuse box in the back next to the battery, running the engine harness through a new hole on the driver's side of the shifter cables, basically learning from everything I did on the Laser and doing it better. It should be hella-clean though. :D
4g63tcrazy
03-16-2010, 10:53 PM
Should look sick! I might have missed it, but what are you doing with the laser shell?
123abc
03-16-2010, 11:02 PM
Should look sick! I might have missed it, but what are you doing with the laser shell?

Selling it. Or if I get enough interest, part it out. I have a thread here for it.
goodhart
03-16-2010, 11:26 PM
Wow! Soon there won't be anything left under the hood of that thing!
123abc
03-17-2010, 02:53 PM
So here's what a stock wiring harness looks like strung out:

http://www.mitsustyle.com/photopost/data/627/medium/SDC11261.JPG

Here's what it looks like all un-wrapped and layed out the way I plan to route it:

http://www.mitsustyle.com/photopost/data/627/medium/SDC11262.JPG

Going to re-do the wires going to the t-stat housing and o2 sensor. Then I just have to wrap it all back up and put it back in the car. :sport017: