View Full Version : 1G Trouble shoot assistance needed
Pages :
1
2
3
4
5
6
[
7]
8
9
10
11
s1ngletracker
11-13-2009, 12:40 AM
dude, if the injectors are bad, it could be causing your problems... Maybe you should look into what the seller told you was wrong first.
No one guaranteed that your PCV, ECU was bad. They were just giving you things to look at.
Have you actually attempted to look into this stuff? It sounds like you're in way above your mechanical ability.
Alpha D
11-13-2009, 12:47 AM
No. Thats not the problem. I already replaced the Intake manifold. I already replaced the o rings as well as upper injector seals. The only thing i have not done yet is the ECU, PCV, and Shifter linkage. I did everything the seller told me to do. That was the 1st Thing i actually did. After that did not solve the problem. I decided to ask for some help and advice. From every one on the forum. The seller says the chip, the mass air flow, everything is in good working condition. If every thing is fine though why is it still acting up. If i could return the car i would.
I doubt that will happen though. So i will sort everything out. Until i run out of funds. Then sell the car.
desolate
11-13-2009, 01:54 AM
Have you performed a compression test? If so what were the numbers? Knowing them will either allow you to point the oil burning problem towards the turbo or motor. Sounds like there's 10 different things wrong at the same time.
s1ngletracker
11-13-2009, 02:17 AM
alright... I'd say at this point you should get your hands on a stock ECU and stock injectors and see how it runs with that. Keep everything simple, and build from there with mods.
Stock fuel pressure regulator? Stock pump? Maybe you should see what your fuel pressure is at.
Alpha D
11-13-2009, 09:58 AM
I have been thinking of going that route. I talked to a few friends about it to. With quite a bit of stuff eliminated will the unchipped ecu be able to sort everything out properly? I want a stock air intake system, mass air flow sensor, cone and everything. The stock injecotrs stock ecu etc.
twack
11-13-2009, 10:14 AM
if your going that route you cant just pul the chip, cause then there would be no tune at all in the ecu. You will need another ecu or find the original chip for it. if your going that route i might have a spare stock chip
Alpha D
11-13-2009, 10:49 AM
Alright thank you twack! I will let you know weather i will go through it or not.
Shane@DBPerformance
11-13-2009, 05:27 PM
If you could put in stock injectors, a stock ECU, and a stock MAS, that would help a lot with troubleshooting it.
scheides
11-13-2009, 09:01 PM
If you could put in stock injectors, a stock ECU, and a stock MAS, that would help a lot with troubleshooting it.
Fantastic idea. You can prolly get all the parts for under $100. Get known good and specificly stock stuff and you'll eliminate all of the above as problems.
twack
11-13-2009, 10:31 PM
i got a 1g maf and the stock chip let me know if you want
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.