Over revving issue

[TheBlizzard]

Who cares if your compression a bit low as long as one cylinder isn't really low, just run more boost to make up for it. Ha ha.

[turbotalon1g]

^good choice.

[Halon]

I took a couple days off as I was researching cobra brakes.

So started back on her today. Oil pan is on. Head is on but not torqued. Got a new axle, thanks to Shane for getting me a good core.

Taking a break here but will be heading back out to torque the head down. Just going to research to see if you're supposed to torque L19's to a different value.

Then start working on putting the cams back in. Maybe get to the timing belt tonight, otherwise I'll just save that for tomorrow.

[Halon]

Got the head torqued on. I decided on 95lb/ft.

Got the cams in and torqed, kinda. I've tried to be real particular about placing everything into seperate plastic bags, but apparently I still managed to lose a singe cam cap bolt. If anyone has one, let me know.

Timing belt is on. Also put in a new tensioner pulley as well while I was in there.

Also picked up a new axle today. Thanks to Shane for hooking me up with an exchangable core.

That's it for today. Will continue on with some more tomorrow.

[turbotalon1g]

Cool man. Good luck.

[Halon]

Thanks Texan :)

I've been working on it a little today. Got the accessory belts on, but left the A/C off for now as I don't even have a belt for that at the moment. Got the valve cover on. Most the electrical crap plugged in. Motor mount back in. Vacuum lines hooked up under the IM. Double checked that the oil pan bolts were still nice and snug.

Started to install the new Arc-2 Unit. I may just leave it installed but disconnected for a little bit though, just so I'm not doing too much at once here.

Also cleaned up all the grease that's all over the wheel well where the axle broke.

[4g63tcrazy]

There no need for that a/c belt anyway.. :)

[scheides]

Brandon if you still need a cam cap bolt, I have one for ya.

[Halon]

Hellz yes I do. You going to be home today, or out n about at all?

[scheides]

I'll be home for about another hour at the most, then going to a wedding. Call on your way over, or you can just get into the garage and grab it. 651.236.0985.