Project AutoX domination!

[MustGoFaster]

From what I can find they are only available in a wussy 17x9 in which case I would keep my $free99 stock 17x8.5's. Show me a 5Z FN01R-C that failed or a Rota P45 that failed WITH A FULL STORY (not just a pic of one that some girl nailed a curb head on at 50 mph) and MAYBE you could get me to think about spending the extra $ on Ray'$ wheels. Show me 10 of each and I will buy Ray's with out question.

I'd go for the orange if I got the 57D's.
http://www.rayswheels.co.jp/emenu/datas2/GRAM/040_57D/01.jpg

[MustGoFaster]

Victory is mine! After a few issues with the trigger side of things, it's done! I haven't tested it on the manifold yet, but my VOM tells me it's good.

Pics for those intrested:
http://www.mitsustyle.com/photopost/showgallery.php?cat=580&ppuser=

Start:
http://www.mitsustyle.com/photopost/data/580/medium/PICT1959.JPG
http://www.mitsustyle.com/photopost/data/580/medium/PICT1985.JPG
http://www.mitsustyle.com/photopost/data/580/medium/PICT1978.JPG


Finished:
http://www.mitsustyle.com/photopost/data/580/medium/PICT1992.JPG
http://www.mitsustyle.com/photopost/data/580/medium/PICT1993.JPG

[MustGoFaster]

AAAHHHH!!! I got good news today, I'm not getting laid off (at least until the economy gets even worse).

But I am now about ready to go crazy. I found these:
Enkei RPF1 17x10 aprrox 17lbs for $1050 shipped.
http://www.enkei.com/jpeg%20files/Wheels/RPF1(17).jpg
The only problem is that I can't confirm that they will clear my calipers with the size/offset I want. There are people running them on the 3S and EVO. My specs should make for as much clearnace as possible, but...

I found the FNO1R-C's for $810 shipped...

Indecision!

[FattyBoomBatty]

spacers.

What does the manifold controller do?

[MustGoFaster]

spacers.

What does the manifold controller do?

I've considered them, but I'm already really pushing the limits as far as rubbing goes.

The controller is for the dual runner length manifold I want to try.

Edit: I ordered them. I think the issue is people trying to run high offsets to avoid having them stick out. But with a 10" wide wheel the highest I can go is ~24mm anyways. Any higher puts the rim into the strut.

[FattyBoomBatty]

low offsets would make them stick out given the same width.

[MustGoFaster]

Your right, I meant high, fixed.

[MustGoFaster]

My wheels showed up today! They clear everything in the front just fine so I'm good to go. They do stick out a bit, but that was expected. I'm willing to solve any issues that causes be any means. Pics

http://www.mitsustyle.com/photopost/data/576/medium/PICT2001.JPG
http://www.mitsustyle.com/photopost/data/576/medium/PICT1996.JPG

And my non calibrated scale confirms the 17lbs, these things are light!

[niterydr]

Sweet :). Needs moar rubber though :).

[Kracka]

Lookin' good.