Fuel System Upgrade

[JET]

Use a nitrous Y in reverse, it gives a smoother transition.

[JET]

Well, I got the car started and idling well. I was in the engine bay and heard a low whooshing noise. I start checking out piping and found that my Spearco FMIC has a 10" long weld blown out! This would explain why it was running like crap for the last dyno day!! Maybe I can get to that this weekend and get it welded up.

[TheBlizzard]

Well, I got the car started and idling well. I was in the engine bay and heard a low whooshing noise. I start checking out piping and found that my Spearco FMIC has a 10" long weld blown out! This would explain why it was running like crap for the last dyno day!! Maybe I can get to that this weekend and get it welded up.

I would say send it back but I am sure you would be better off just welding yourself. Where did it blow out?

[JET]

It blew out on the bottom end tank on the engine side, right in the middle.

[Kevin 1G Drummer]

I heard the car idle today. Sounds pretty badass :)

[FattyBoomBatty]

Sounds like it'll be a winner.

[JET]

Here is a pic from the back. Click on it to blow it up.

http://img1.putfile.com/thumb/5/12013203045.jpg (http://www.putfile.com/pic.php?img=5362592)

[Pushit2.0]

If your IC cracked once I would re-weld all the joints on the end tanks that are longer then a few inches, or it will crack again. It takes a long time to grind out the welds and clean everything up to lay down a new good weld. Did you get your Tig torch cables fixed?

~John

[92EvilTalon]

Here is a pic from the back. Click on it to blow it up.

Hahaha Jet you are funny. Not a good way to say something about a fuel cell. And yes that looks very sweet ....

[JET]

Yeah, I was planning on redoing all 4 welds that are pretty long. No point in having to take it off again! My TIG is up and running again.

I thought I might get a comment about the blow it up part :D