act 2100/fidanza

4G63Spyder · 11-12-2005

just installed a fidanza lightweight flywheel/act 2100 street disc combo in my 2g GST...now my pedal is very soft, comes up from the floor slowly, is very very light, and engages about 1/2 inch from the floor....IS THIS NORMAL?

This is my first clutch swap ever, completed in a little less than 8 hours...wow what a PITA that was

CDeutsch · 11-12-2005

Did you bleed the clutch line? I'd start there.

**1ViciousGSX** · 11-13-2005

Bleed system and properly adjust the clutch rod under the dash.

4G63Spyder · 11-13-2005

doing that tomorrow...ran out of time and had to go...

what does your normal pedal pressure feel like?

**1ViciousGSX** · 11-13-2005

Mine feels like a 2500lb ClutchMasters.

4G63Spyder · 11-13-2005

a lot stiffer than stock then? Mine is very very light, even after bleeding....I don't get it.

**1ViciousGSX** · 11-13-2005

The 2100 is not too much stiffer feeling then stock. I used to have one.

Check your push rod adjustment.

CDeutsch · 11-13-2005

Mine is pretty light, close to stock.

EclipseGST · 11-13-2005

Did you bleed the clutch when the car was level? I have had problems before because of the front end being off the ground so it doesnt bleed right. Make sure its level and bleed it again. Its not to hard to do it while its on the ground.

4G63Spyder · 11-13-2005

hmmm..i did it on the ground, but my driveway is sloped. I'll try it again on level ground soon. Car's not running waiting on the new turbo!