need help with master/slave cylinder install

BKs50trimGST · 12-16-2005

I was wondering if anyone could take the time to install these parts:

2g clutch master cylinder
2g clutch slave
SS clutch line

I was also wondering how much it would cost for an install. My dad has a shop that is heated and has many tools or I could bring the car to your place as well for the install. I would do this myself but I really don't want to screw it up, plus I dont have alot of time. I have all the parts needed for the install, just picked them up from Brookdale Mitsubishi.

Call me at 612-730-5165 or pm me if you are interested in helping.

Thanks,

Brian

**scheides** · 12-17-2005

Just FYI, this is really, really easy to do. Master cyl will be the toughest part, but I did this in the freezing cold of my old garage with no jack. Just follow the vfaq and make sure to bleed the line when you're done.

Jakey · 12-17-2005

RTFM, it's easy.

s1ngletracker · 12-18-2005

Agreed. I did my MC in my garage in about 30 mins, which included a full bleed to get the fluid coming out clear.

BKs50trimGST · 12-23-2005

ok, i'll pay u a reasonable price today if someone can get back to me asap, i need my car fixed today - prefferably in the next few hours, call me at 612-730-5165 brian

s1ngletracker · 12-24-2005

Did you get any replies? Its probably a bad time to find someone to do it... with christmas and all. If possible, you might wanna park it until after the holidays. If its your only car I feel for ya, been there done that.