MitsuStyle MitsuStyle

Go Back   MitsuStyle > Tech > Turbo / Engine / Drivetrain

Thread Tools Display Modes
Old 06-13-2018   #1
mark4g63t's Avatar

Join Date: Jun 2012
Location: Twin Cities
Drives: 95 Talon TSI
Posts: 940
Transmission rebuild

Hey guys, in the middle of rebuilding my transmission (2g awd) because my input shaft bearing went out. How are you guys shimming the trans to get the correct preloads for the bearings? I know of the solder trick, but since they don't sell the shims anymore i'm curious as to what people are using. Jacks told me about "shim in a can" which looks to be just machined sheets of steel that i would need to cut circles out of for the shims, has anyone used this or have any shims?!?
BW8776, e-85
mark4g63t is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 01:34 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.