Here is what you need.............
Was all used for about 800 miles.
P-Trim 67mm T4 .58A/R (different exhaust housings T3 .63, T3 .82, T4 .68 ,or .T4 .83)
Turbo has 0 shaft play and no chiped fins
2.5 90 welded on the compresser cover
PTE 600 HP IC (over all 31.5L x 8H x 3.5D 2.75 In and out.)
Tial 38mm WG .5 bar spring (black)
38mm WG flang, gaskets, and some piping
Tial 50mm BOV (black)
With flang and O-ring
K&N filter
-4 feed line with 1/8ntp 90 for tubo
-10 return with 90 degree fitting (12 ichcs long)
T bolt clamps
V-band and clamp
Old down pipe (3 inch) O2 bung in DP
2.5 inch pipng
$1500 is worth $2840
Auto Meter spot comp gauges
Boost 30psi (mechanical)
Water temp (electric with sensor)
Volts (electric)
Oil Pressure (mechanical)
Aem wideband with sensor
$400 bucks
Linear Mode
