I switched to an Evolution intercooler on my car and no longer need this one.
PO installed it, I don't know too much about it other than it's physical attributes.
The core measures 21x9x2.5 inches.
Inlet to inlet width measures 28 inches.
Inlet OD measured 2.25 inches.
End tanks were cast. One has a scrape on one corner. PO had the core attached to the car with ONE sheet metal screw and a shoelace. That's not a joke.
I've taken a picture to show the damage. It held pressure when it was on the car. The rest looked in good shape, fins were in decent shape as well.