1G Roll Bar

[TwoTalons]

Kirk Racing Products bolt in 4 point roll bar for 1G DSMs. 1.75" x .120" DOM. Excellent condition.

$220

[twack]

do you have to remove the rear interior for this

[TwoTalons]

Originally Posted by twack

do you have to remove the rear interior for this

I don't think so but I can't say for sure. Never installed it. I've had it for a few years. The guy I bought it from had his interior removed but he was racing the car.

[sleepydsm]

So could you just add door bars to this to make it an NHRA legal 6 point? Or would you have to weld it in also?

[Kevin 1G Drummer]

I don't think it can be made NHRA legal considering some of the tubes bolt together.

[twack]

what if once you installed it you welded those tubes together

[turboimports]

I believe plate dimensions are off too just from looking.

[Kevin 1G Drummer]

Originally Posted by turboimports

I believe plate dimensions are off too just from looking.

+1, The plates need to be 6"x6" and those look rectangular. It would still be a nice kit for someone to run with on the streets though.

[turboimports]

Looking for anything? Maybe trades?

[twack]

pm'd

[TwoTalons]

Originally Posted by turboimports

Looking for anything? Maybe trades?

Need a good short block. Preferably a 2.3/2.4.

[TwoTalons]

Originally Posted by sleepydsm

So could you just add door bars to this to make it an NHRA legal 6 point? Or would you have to weld it in also?

Wish I could help but I know nothing about NHRA rules. Don't see why it couldn't be modified to make it legal though.

The guy was road racing his car. Never ran it on the drag strip as fas as I know.

[Swifty1638]

for it to be legal, the cage MUST be welded. Bolt-in cages do not work.

[twack]

sold thanks keith

[TwoTalons]

Originally Posted by twack

sold thanks keith

Thank you!

[Halon]

Originally Posted by Swifty1638

for it to be legal, the cage MUST be welded. Bolt-in cages do not work.

That's not my understanding, unless something has changed from 08 to 09

This is taken right out of section 4:10 of the 2008 NHRA Rule Book:

Unibody cars with stock floor and firewall (wheeltubs
permitted) may attach roll bar with 6-inch x 6-inch x .125-inch
steel plates on top and bottom of floor bolted together with at
least four 3/8-inch bolts and nuts

[Goat Blower]

I think the diameter and wall thickness is a bit light for NHRA as well, I can't remember anymore. I know that you need larger diameter tubing when using mild steel than the autocross guys use.