Will this work ok for porting or?

howslowcanyougo · 06-05-2005

Got a nice 2G Exhaust mani off this board that I was thinking about porting myself, do you guys think this INGERSOLL Die Cutter would work out ok to complete this kind of job?

http://cgi.ebay.com/ebaymotors/ws/eB...category=63693

TIA......

Howie

unreal808 · 06-05-2005

**JET** · 06-05-2005

Yeah, that would work, then you need the carbide bits, grinding stones and polishing wheels. Figure at least $40 in bits.

howslowcanyougo · 06-05-2005

Quote:

Originally Posted by JET

Yeah, that would work, then you need the carbide bits, grinding stones and polishing wheels. Figure at least $40 in bits.

Ok, so what would you or Mike typicaly charge for a descent port on a 2G mani then?

**JET** · 06-05-2005

I charge $60 for an exhaust manifold.

9guy9 · 06-06-2005

I got a grinder just like that off the local SK/Cheap tool truck for like $30. I've been using it at work almost daily, for over a year. You might want to check around local. Most of the cheaper ones are the same with different names slaped on them.

This place has some nice bits at a good price. http://www.harborfreight.com/

howslowcanyougo · 06-06-2005

Quote:

Originally Posted by JET

I charge $60 for an exhaust manifold.

I'll PM you later on this k?

Thx.....

howslowcanyougo · 06-06-2005

Quote:

Originally Posted by 9guy9

I got a grinder just like that off the local SK/Cheap tool truck for like $30. I've been using it at work almost daily, for over a year. You might want to check around local. Most of the cheaper ones are the same with different names slaped on them.

This place has some nice bits at a good price. http://www.harborfreight.com/

Thanks much for the good info!