05-30-2010
|
#1
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Rebuilding the 87 Conquest TSI
Picked up a 87 Atlantic Blue quest two days ago around midnight. Its just a roller. Has dings which looks to be from hail on the roof and the hood. Had some squirrels living in it, found some acorns in the glovebox and under the wiper cowl. Plus the carpet had what looked to be squirrel shite all over it. The following day I started to remove the front end for small rust repair.
Fixed some rust and used rubber undercoating in the fender wells and on the frame rails. Then sprayed the front section and engine bay rails down with black rustoleum paint.
Edit "Friday April 29th 2011" Mod List Below
Rebuilt Bottom End, Stedebani 95A Motor Mounts, Balance Shaft Elimination, Jet Valve Elimination, Throttle Body Rebuild, Krank Vents, MK1 Egr Block Off, GM Delphi Injectors, GM 110 Amp Alternator, Alternator Ground Strap, Transmission to Firewall Ground Strap, Dual Alternator Charging Harness, Optima Red Top, 1G Maf, TD05-12A, KDM Turbo Small Discharge Pipe, KDM Turbo Inlet Pipe, TEP Ovcp w/ Turbo-Xs Type H Bov, 14.5psi Boost Pill, 2.5" Catless Turbo Back, Stock Twin Tip Muffler, 83 Starion 2 Piece Crank Pulley, Rodded Stock Radiator, Accel Yellow Coil, Accel 8.8 Wires, Fram Oil Filter, Rotella T6 Full Synthetic, New Coolant Temp Switch, New Master Cylinder/Water Pump, A/C Delete, Abs Delete, Star-Orion Abs Line, Steel Braided Turbo Oil Feed Line, Charcoal Canister Delete, Anti-Roll Over Valve, 89 Ecu, 89 Airdam, 89 Rear Starion Shoulder Belts, 89 Rear Seats, 89 Hvac Panel, Grant Steering Wheel, Stedebani Short Shifter, Eibach Rear Lowering Springs, Suspension Tech Front Lowering Springs, Shp 8 Way Front Struts, Kyb Gr2 Rear Struts, 90/100 Watt Relayed Headlights Harness, H4 Headlight Housings, Silver Star H4's, 55 Watt Foglight Bulbs, Foglight Mod, Resprayed Flat Black.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
Last edited by C89ZX7R; 04-28-2011 at 11:35 PM..
|
|
|
|
05-30-2010
|
#2
|
Join Date: Oct 2003
Location: edward lake
Drives: toaster
Posts: 6,431
|
Re: Rebuilding the 87 Conquest TSI
Not bad looking
But stop using bold type. Reg. Is just fine
|
|
|
|
|
05-30-2010
|
#3
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Quote:
Originally Posted by TkrPerformance
Not bad looking
But stop using bold type. Reg. Is just fine
|
Fixed 
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-01-2010
|
#4
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Tuesday will bring
Pulling the dash
Upgrading the Ecu harness from 87 to 89
Engine bay painting
Hopefully wire tuck both harness's!
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-02-2010
|
#5
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Was raining on Tuesday. Removed some more parts off the 88 parts car to get it ready to be picked up by the body guy. Replaced the sunroof shield on the 87 project. Also cleaned under the wipers and removed the squirrel shite and acorns from that area. Hopefully I will be able to finish the engine painting on Thursday and replace the rotors and pads. Ordered a Star-Orion "Abs" bypass line and a Mokeeh Egr block off last night.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-03-2010
|
#6
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Sprayed the rest of the bay, then it rained a few hours later. It was dry by the time it started to rain.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-03-2010
|
#7
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
May use "Monstaliner" on the exterior of the car, will be using it to replace the carpet!
Example pic on how this stuff looks!
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-09-2010
|
#8
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-09-2010
|
#9
|
|
Banned
Join Date: Dec 2003
Location: Boulder, CO
Drives: Conquest
Posts: 5,049
|
Re: Rebuilding the 87 Conquest TSI
I'll sell you a brand new airdam just spray painted black for $200 bucks plus $20 for shipping. That's way better than you will find elsewhere, as far as I know.
|
|
|
|
|
06-09-2010
|
#10
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Quote:
Originally Posted by FattyBoomBatty
I'll sell you a brand new airdam just spray painted black for $200 bucks plus $20 for shipping. That's way better than you will find elsewhere, as far as I know.
|
Black car has a brand new freshly painted 88-89 airdam.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-09-2010
|
#11
|
|
Banned
Join Date: Dec 2003
Location: Boulder, CO
Drives: Conquest
Posts: 5,049
|
Re: Rebuilding the 87 Conquest TSI
Not the blue car though.
|
|
|
|
|
06-10-2010
|
#12
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Quote:
Originally Posted by FattyBoomBatty
Not the blue car though.
|
Black one has turned into the donor car for the blue one.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-10-2010
|
#13
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Pain in the ass "one" piece exhaust!!!
Pulled the rebuilt motor from the 89 Conquest.
MK1 Egr Block Off Plate Installed
Almost in, angled motor mounts are a pain in the ass. Of course so is gravel, grass and a engine lift.
Bolted down!
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-10-2010
|
#14
|
Join Date: Jan 2009
Location: prior lake
Drives: to the shop
Posts: 411
|
Re: Rebuilding the 87 Conquest TSI
looking good!!! i want one so bad
__________________
93 talon tsi/ 6 bolt swap
Mitch
|
|
|
|
|
06-15-2010
|
#15
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Removed the old nasty odor stinking insulation from under the dashboard! Squirrel Shit Filled Dash, A/C, Heater Core, Blower Motor and Insulation has been trashed.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-21-2010
|
#16
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Interior is 99.9 percent completed
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
|
06-21-2010
|
#17
|
Join Date: Nov 2007
Location: lino lakes
Drives: 98 GSX, 04 is300
Posts: 1,856
|
Re: Rebuilding the 87 Conquest TSI
Wow a fast and intteresting project build. I like it!
__________________
98 GSX (built)
03 BBY EVO dd
GSX 463awhp 363awtq on DB!
|
|
|
|
|
06-21-2010
|
#18
|
|
Kevin
Join Date: Jan 2004
Location: Shoreview
Posts: 3,356
|
Re: Rebuilding the 87 Conquest TSI
Keep up the good work!
__________________
Misses the Mitsu Community
Currently on Corvette #4
|
|
|
|
|
06-21-2010
|
#19
|
Join Date: Nov 2005
Location: Cottage Grove
Drives: Silver '02 IS300, Blue '06 Suzuki SV1000
Posts: 5,293
|
Re: Rebuilding the 87 Conquest TSI
Those seats remind me of those super puffy winter jackets people always wear.
__________________
'02 Lexus IS300
'06 Suzuki SV1000: Back on the road and ripping hard as ever!
|
|
|
|
|
06-24-2010
|
#20
|
Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
|
Re: Rebuilding the 87 Conquest TSI
Installed the one piece exhaust, had to use the engine lift to lift the entire car up in the air to do so.
Isc, Tps and Dist plugs needed to be added to the harness.
Wiring fun!
Finished the wiring.
__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
|
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|
