Will my 7 bolt hold?

GsXtUrBo98 · 03-16-2009

I have enough mods to hit 300-350awhp and I was told it will blow up... I have arp's and all that stuff to support it. What do you guys think??

I'm planning on running 20psi on a scm6152e

Dundars · 03-16-2009

Yes.

Edit - What dyno do you plan on making those numbers on? Good luck hitting 350awhp on a Dyno Dynamics at that boost level on a 2.0.

GsXtUrBo98 · 03-16-2009

My goal is 300 so I wont be dissapointed if I dont make 350...

I have my upgrades on here as my spring upgrades and that has all the stuff I am running on it...

**goodhart** · 03-16-2009

Quote:

Originally Posted by Dundars

Yes.

Edit - What dyno do you plan on making those numbers on? Good luck hitting 350awhp on a Dyno Dynamics at that boost level on a 2.0.

It shouldn't be that tough depending on the mods it should be damn close, especially on E-85.

E-85 setups like this are making between 450 and 500 with big enough injectors on Dyno Dynamics.

You won't blow your motor either, there's guys making more power than this on 7 bolts just fine.

**goodhart** · 03-16-2009

Dundars · 03-16-2009

Stock 2g rods still I'm assuming?

If yes, that and crankwalk will be your only weaknesses, but I highly doubt you will run into crankwalk or a bent rod at that power level.

GsXtUrBo98 · 03-16-2009

Its a jaster long block with 40k on it and the balance shaft eliminated... as far as I know its all stock internals because the guy before me put it in....