|
Re: Dumb question inside...only read if u arent gonna flame lol
IF you have the time to sit around, you can go to tires plus, or any place like that. They have a lathe that will cut your rotors for ya. Also, you can turn, and measure thickness on drum rotors. My old job had a machine for that too( usually, they are both as one big machine-disks, and drums) the micrometer was a little different, and it measures the inside if the drum. Take the measurement at different points, and you can usually tell if they are good or not.
-A. Swift
Last edited by Swifty1638; 03-11-2005 at 07:59 PM..
|
Threaded Mode