Mark's 1G Winter Projects

[Mark Leasure]

Made some progress last weekend, I dropped my transmission and installed a 300m output shaft. The new shaft is on the right:



I also finished up the ss to aluminum joint transition on the exhaust and routed it under the oil pan. 4"is a very tight fit. It's lessential than 1/4 inch of clearance between the transfer case and oil pan, measure twice and cut once!



The oil filter looks a lot closer than it really is, over an inch away.



I need to get one more vband aluminum flange to finish up the exaust. I really like the Vibrant quick vband clamps with male and female flange sections for alignment.