Andre's 2g GSX build

[b00sted_spyder]

DSS driveshafts are overrated. I've seen a DSS wrx shaft come in and it had a ton of runout. Either they built it like crap or the owner really fucked it up. The welds weren't even nice looking. 799.99 is a lot for an aluminum 3" 1310 series. Keep in mind that it only eliminates the front hanger. So instead of a 3 piece shaft, it'll be a 2 piece reusing your last section with the hanger. With the 300m output shaft, i believe it takes a c4 slip yoke from a ford which is a 1310 series joint. It takes a much bigger joint than the dsm joint. We are also starting to sell CF driveshaft. But it is not built in house. They are glued to the aluminum end yokes. Very precise driveshaft. But once it goes bad, it's garbage.