Perkul8r's Rebuild.

[Perkul8r]

Okay, so i got a quick question. I was comparing the motors in my laser and talon, now that i got the head off. Well, the pistons in the Talon are just labeled 63D and the ones in my laser are marked 63D T. So does that mean the motor in the talon is not an actual turbo motor? Also it looks like something happened with the #1 piston. it did hit the head, but ever so slightly. There is only one valve i am really concerned about, it sits in the seal about 90% around, but there is just a little bit that doesn't. Is it ok that I replace that valve? Thanks again.

[Chim55117]

Originally Posted by Perkul8r

Okay, so i got a quick question. I was comparing the motors in my laser and talon, now that i got the head off. Well, the pistons in the Talon are just labeled 63D and the ones in my laser are marked 63D T. So does that mean the motor in the talon is not an actual turbo motor? Also it looks like something happened with the #1 piston. it did hit the head, but ever so slightly. There is only one valve i am really concerned about, it sits in the seal about 90% around, but there is just a little bit that doesn't. Is it ok that I replace that valve? Thanks again.

63D = Naturally Aspirated
63DT = Turbocharged

[Perkul8r]

thats what i thought. So if i do use this head, should i swap in my turbo cams?

[Perkul8r]

So i ordered 2 new valves today, and a spring compressor, couldn't find one here in town. Gonna Switch out the two that may be ever so slightly bent, and than gonna throw in my turbo cams just to be safe. Am hoping to get the head on by friday night. but we'll see.