I got the throttle body back this week and installed it last night. Fired it up today and there was no more air leak so my seals on the throttle body were shot. Steve at
www.throttlebodys.com did a great job on the rebuild. Took it out for a spin today and when I got back to my garage and stopped I let it run for a little bit and it stalled out. I had this problem before and I just adjusted the BISS screw so I'm going to adjust it again and that should work that kink out.
Also my tranny is slipping at times during acceleration. A buddy of mine and I were looking at it a few weeks ago and we figure that my tranny is starting to go so I am currently looking for a used 1G AWD 6-bolt tranny. The tranny I have in now is a 7 bolt on my 6-bolt engine and it sounds like its hitting a little bit.
Hybrid Mode
