1g FWD Exhausts?

[carltalon]

My exhaust is pretty simple. I have two 3" 45* bends one thats pretty mutch right under the axil to go up and over and one to bend it straight back to the stock exit area. I just have a cheap Ebay straight through muffler. If I did it again I'd add a resonator inline somewere.

[1QUICK4]

I had the Thermal Research on my 90 Laser. It was 3" and went over the rear.

Was the best sounding exhaust out of all my DSMs

[4g63tcrazy]

Originally Posted by carltalon

My exhaust is pretty simple. I have two 3" 45* bends one thats pretty mutch right under the axil to go up and over and one to bend it straight back to the stock exit area. I just have a cheap Ebay straight through muffler. If I did it again I'd add a resonator inline somewere.

The only thing I don't like about your's is that it goes right under the gas tank. I would at least put some sort of heat sheild there.

[carltalon]

Originally Posted by 4g63tcrazy

The only thing I don't like about your's is that it goes right under the gas tank. I would at least put some sort of heat sheild there.

I was kinda worried about that at first. But its been like this for 5 years with no pronlems.

[123abc]

Originally Posted by carltalon

I was kinda worried about that at first. But its been like this for 5 years with no pronlems.

Mine use to be under the gas tank thats why I cut it off and stuck the muffler on. It scraped on everything.


What I want to do is put maybe 2 3 inch cherry bomb glass packs in the center hump and then just run stock 3 inch mandrel bent tubing out the stock location and routing. It can't be that hard to make it go over the rear axle, can it?

[carltalon]

Originally Posted by 123abc

Mi It can't be that hard to make it go over the rear axle, can it?

My car is lowered at least 2 inches so I dont think theres mutch room above the axil. I mostly wanted to make it with the least amount of bends possible. less restriction less cost and less work fabing it.