Oh fun! Spun rod bearings!

[Tachyon]

Originally Posted by blackrosenova400

http://www.aclperformance.com.au/us/...bearingsus.htm


There ya go, you can see which bearings are supposed to be up in the block and which ones should be in the cap. You accidently had a couple mixed up. The caps you pulled that we looked at, the grooved bearings should have been in the block.

What are you gonna do next?

Yup. I referenced that when you left. I feel really fucking stupid right now...

Originally Posted by sleepydsm

This is a bad week.... Sorry to hear! Are you gonna build another motor?

You're damn straight I am. I am debating if I should try and get it done for the cruise... I have another 2.4 6-bolt crank and some spare bearings. I probably could do it, but I am rather gunshy right now.

[4seasons69]

Originally Posted by Tachyon

Yup. I referenced that when you left. I feel really fucking stupid right now...



You're damn straight I am. I am debating if I should try and get it done for the cruise... I have another 2.4 6-bolt crank and some spare bearings. I probably could do it, but I am rather gunshy right now.

man that sucks big time! at least you figured out why it spun. I say go for it since you figured out why it happend. just cause you fall off a horse doesn't mean you shouldn't get back on

[blackrosenova400]

Meh we all make mistakes.

Originally Posted by Tachyon

Yup. I referenced that when you left. I feel really fucking stupid right now...



You're damn straight I am. I am debating if I should try and get it done for the cruise... I have another 2.4 6-bolt crank and some spare bearings. I probably could do it, but I am rather gunshy right now.