|
Re: Engine Building-What Products?
Be sure to have them set the valve guides a little under stock height. That will give you room for big cams. Go like .050" under just for good measure. Mine were all over the place when I got mine back, I took it back and had them redo it.
I have an almost identical engine. Wiseco 8.8's, eagles, ACL bearings, ported head with Crower springs, Fidanza cam gears, SI 1mm over SS nitride coated valves. You will be really happy with the setup.
__________________
Is burning corn and stayin' warm!
My motorcycle is stock and reliable, my Talon is neither!
Last edited by JET; 10-29-2006 at 11:07 PM..
|
Threaded Mode