|
Re: GsXtUrBo98's 2G project thread
I got the new master cylinder today and installed it, then bled the clutch/slave and adjusted the clutch. I WORKS! it no longer ingages at the floor! it does however slightly move when the clutch is in and I rev it up but not bad at all.
On a side note I took it for a drive and the steering wheel shakes and when I turn right I hear a grinding noise.... This is just depressing
__________________
98 GSX (built)
03 BBY EVO dd
GSX 463awhp 363awtq on DB!
|
Threaded Mode