Clutch Low Engagement(yea, I know it's a DSM)

[iceminion]

Install new master and slave cylinders...but it wont fix it.

I run synthetic fluid (purple looks cool) (will not soak up water)

You will most likely need to extend the master rod...might want to take care of this before you install the new one....will save you time later...you only need to extend it a total of 1/2 inch.

You can have any shop do this

The thread you will need is m8x1.25

cut off 1.5 inches, and weld on 2 inches of thread.

Gotta love freaken 1G's setup.

Remember the extended SLAVE rod doesnt do anything to solve the problem.

The problem is there is not enough fluid being pumped through the master slave cylinder by the defective and failing design of the 1G clutch setup.