|
ECU - DSMlogger HELP!!
Hey, I am having a problem with my car. I have been in the process of getting my DSM back on the road for about 9 months now and I'm almost done. Last spring I bought a S-AFC. Well needless to say I cut a wire on my ECU, I believe it was a green wire, maybe had a blue strip on it but I know it was the green wire on the big clip. I didn't have enough wire after splicing the rubber coating off to reconnect n twist them together. So I got a old wall connected cable (plug-in type, like in a lamp) and I cut it up and solder the 2 green wires using that wire together. Basically I dont know much on wiring and my DSMlogger is saying I have a ECU Comm Error. Is the wire I used going to work or is that why its tripping that code? I used a silver wire to connect the 2 coppers.
I no longer have the S-AFC so I soldered the wires back together, taped it up, plugged it back in. I started the car it ran, a little boggy but that could be because of the improperly tuned BISS. I ran DSMlogger MMCd
Active 21 22 23
43 44 36
Stored 21 22 23 43 44 36 25 31 41
21-Coolant Temp Sensor 22-CAS 23 TDC Sensor 25 - Barometric Sensor 31 - KNock sensor 41 Injector Circuit 43-EGR 44 Ignition Coil 36 Ignition Circuit
Any idea on these, I know my coil Pack is bad so is that tripping the 44 and 36? I have rubber caps on my TB fittings is that tripping the 43? A fuel leak was on the fuel rail when I started it up and the BISS is adj. improperly is that the 41? Im low on Coolant is that the 21?
WTF is a 25?
I'm sorry guys but i really need help.
|
Threaded Mode