4-point NHRA legal roll bar for 1G

[Goat Blower]

Just cut it out of my car yesterday, I'm not planning on running at the track much anymore, so it's just in the way. Mild steel, correct wall thickness and diameter for NHRA down to 10.0 if it hasn't changed in the last few years. Side bar is long gone and you'll need to make some base plates and weld it back together, but the hoop and rear bars are there.

I don't want anything for it other than some good condition gray rear lower side panels with rear speaker grill covers in place, must be nice, not scratched or faded. I'll throw mine in with the bar, speaker covers are cut for the rear bars and trimmed appropriately.