Looking for some Mandrel pipe

[Onefast99gsx]

I'm working on my Magnus project. I need some mandrel pipe to finish the job. I need 2 1/2" and approx. 70* bend. I have a 45* and a 90*, one is not enough and the other is too much. Does anyone know where i can get that?

Thanks.

[john]

Just cut the 90 at an angle. If you do not want to do that, call Mike at QPR or PM jet.

[EclipseGST]

Cut the 90*? Probably will be the fastest way you will get a 70* bend is if you cut the 90* pipe. I dont know anyone around here that has a mandrel bender cause they are very expensive. Just my $.02~

[A//// Guy]

Cut 90, make 70, weld together, grind off welds, polish or paint

I dont know any mandrel places around here but it would be spendy anyway.

[Onefast99gsx]

Yes, i know what you mean. Cut the 90*, grind or cut an angle on each half and rejoin the 2. Works for me.

Thanks.

[CarPsyco84]

Headers by Ed in Minneapolis has some, really tight radius 3", its gonna cost you around $30 bucks though, otherwise order from summit...

[95tsi]

Cremco (i believe is the name) is in Lichfield, MN. Can pretty much get whatever you need. They have the actual mandrel bending machine...

[Shotgun!]

J&S can do anyting as well...calling raptor!