first time head replace ..

[way2fastalon]

well i think i found out the problem with my new dsm i bought it this way i think the exhaust cam is out of time by a lot and i think it bent a few valves makes a bad noise when running im sure its not a rod cause there would be shinny things in the oil and would run fine until u rev it but that's not the case the engine wont rev and hesitates very hard to start .
so ill post pics of the head im hoping its that and not something stupid

[way2fastalon]

well i gessed right it was bent valves there are a few imprints on the pistons where the valve reliefs are looks like there was contact 2 and 3 had it the most the valves stick out a 1/16 in just barely