ACL race bearings rod/main (.010"/.25mm) over

[iceminion]

Still in plastic, never used, the turned crank i was going to put in the engine was THROWN AWAY BY SOME FEMALES CLEANING THE BASEMENT

New is about $80, PM me an offer

[Twitch]

Will these work with a 6 bolt and if so what do i need to do to get them in

[iceminion]

I did not clarify, yes, these are for the 6-bolt, and for your "what do i need to do to get them in" question, there are bearing installation steps, its kinda hard to type out, I would be more then willing to help install them with you to make sure everything is done right.

Mods: It looks like I posted this in the non-mitsu side of things, can you move the thread please?