help with a new clutch master install

[viridionplague]

as the title says i could use some help installing a new clutch master.

the sooner the better as it gets closer and closer to being towed

[twack]

whats holding you up. its pretty straight forward

[123abc]

Originally Posted by viridionplague

as the title says i could use some help installing a new clutch master.

the sooner the better as it gets closer and closer to being towed

2 12mm bolts, a 10mm nut holding the line to it, and a 12mm locking nut under the dash and rotate the rod out. How hard is that?

[viridionplague]

some help bleeding it would be good, im not 100% on the bleed procedure, and its a 2 person job

[123abc]

Originally Posted by viridionplague

some help bleeding it would be good, im not 100% on the bleed procedure, and its a 2 person job

Ah, I suppose bleeding is a 2 person job. My bad. Basically, one person is in the car, one under it. Person pumps the clutch pedal and holds it to the floor. The person under the car loosens the bleeder screw to let air out and then tightens it back up. Person in car pulls pedal up and repeat process.

[At-Least-It's-An-Evo]

if its already installed, i may be able to help depending on how close you are, i may have like a 15 minute time window open this evening.

[viridionplague]

well the old one is 90% out, the 2 firewall bolts are pretty much off and the adjustment rod is out, just need to pop the lines and pop the new one in.

and i read so many different ways to bleed, some say bench bleed, some say gravity.

i just really need this done right

[At-Least-It's-An-Evo]

Originally Posted by viridionplague

well the old one is 90% out, the 2 firewall bolts are pretty much off and the adjustment rod is out, just need to pop the lines and pop the new one in.

and i read so many different ways to bleed, some say bench bleed, some say gravity.

i just really need this done right

If you can get the line off without twisting it using a flair wrench or so, thats the "hardest" part. Where do you live? maybe I can help out tomorrow if it's not too big of a rush and not tonight?

[viridionplague]

tomorrow would be fine, just need it done as soon as possable, i wont have the part till around 430 or so anyways so it will be dark.

i live out in blaine, up off 133rd and 65/central

[viridionplague]

just wanna mention i got this resolved, just went at it and it worked pretty well, thanks to all those who offered help.

please close this thread