while removing my lower control arm, I believe it is, one of the damn bolts just broke from being so rusted. so then we drilled out the part of the bolt that broke inside and started tapping the hole, but then the tap broke (yes I know, wtf) so now I need to figure out how to get the broken part of the tap out of the hole, does anyone have any suggestions? I know taps are 10x more a bitch to get out than a broken bolt but at this point any suggestion is a good suggestion.
(yes I know, wtf) so now I need to figure out how to get the broken part of the tap out of the hole, does anyone have any suggestions? I know taps are 10x more a bitch to get out than a broken bolt but at this point any suggestion is a good suggestion.
Threaded Mode