Hydraulic clutch issues...

[volcomamskater]

Hey, I couldn't find anybody who had this problem in the forum anywhere. Me and my buddy Terre just installed a new ACT 2100 clutch into my 97 GST, after we got it done we bled the system even though we didnt open it up. But now the push rod by the clutch pedal that you can adjust keeps giving me problems, I think the first time I put it to far into the master cylinder, because the clutch was hard and stiff, so I brought it back out a bit, that made it to mushy, so after some fandangling I thought I got it to where I liked it. Well then I'm guessing it adjusted itself or something and even though I tightened the nut on the rod, the clutch pedal became hard again and wouldnt shift into gear, like it was always engaged. I bought a new slave cylinder, yet to install and ordered a new master cylinder. But other than that does anybody know or have had this kind of issue? Any comments are appreciated, thanks.