|
Re: Dynoed my car before I broke it.
Worked on the car some this weekend. Pulled a lot of parts out of the head, but the valves don't look too bad. When I pulled the transfer case off, the output shaft pulled out of the tranny a bit and started pouring our fluid, so my little aluminum TRE VC eliminator either broke or fell off. There were some more rocker parts in the oil pan as expected. I didn't feel any signs of spun rod bearing from wiggling the rod caps. I pulled one of them off and the bearing looked ok, some of the white coating had worn off, but that is something I would expect.
|