MitsuStyle - View Single Post

sleepydsm · 03-07-2009

I picked up my TurboX coated parts from Bob at Map today. I went over to the car and put some of it on. I realized I'm gonna have to cut a lot more off my downpipe than I thought, and I need to chop part of my compressor cover outlet off and weld on a 90 elbow.

The drain is gonna be kinda funky. I might need two 45 degree -10 fittings to get it to work right.

I also need some more 02 housing bolts, I should most likely order new turbo bolts and lock washers from mitsu.

I have to fab up my 4" intake, v band downpipe, a oil drain, install cams and new OFH and oil cooler, and set up Link!

03-07-2009	#161
sleepydsm Kevin Join Date: Jan 2004 Location: Shoreview Posts: 3,356	Re: My Talon I picked up my TurboX coated parts from Bob at Map today. I went over to the car and put some of it on. I realized I'm gonna have to cut a lot more off my downpipe than I thought, and I need to chop part of my compressor cover outlet off and weld on a 90 elbow. The drain is gonna be kinda funky. I might need two 45 degree -10 fittings to get it to work right. I also need some more 02 housing bolts, I should most likely order new turbo bolts and lock washers from mitsu. I have to fab up my 4" intake, v band downpipe, a oil drain, install cams and new OFH and oil cooler, and set up Link! __________________ Misses the Mitsu Community Currently on Corvette #4 Last edited by sleepydsm; 03-07-2009 at 07:52 PM..