|
Re: Finally getting stuff done on our cars
Quote:
Originally Posted by Jakey
If I were you, I'd get a 100% stock housing and send it off to Advanced Design Concepts to get a CAD model made. It is nearly impossible to 100% reverse engineer a piece like this without some sort of laser scan or touch probe because of all the fine details. By having a CAD model, you could have someone run an FEA simulation on the piece to determine where the stress concentrations are and then be able to specifically target your reinforcements.
|
Or you could just weld reinforcements and call it good. Some of y'all over complicate this stuff.
__________________
2009 Corvette Z51-SOLD
1992 Mitsubishi Eclipse GSX-SOLD
2013 BMW Z4-Current summer hooptie
2017 GMC Yukon-Current winter hooptie
|