Quote:
|
Originally Posted by S2kracka
You could always buy the cast GReddy (or maybe it was Apexi) endtanks and custom fabricate a 1G setup around them.
|
http://www.greddy.com/products/displ...SubCategory=21
The Greddy endtanks do looks very nice however, without seeing some CFD maps, I do not believe that they can compete with the DV/DT endtanks.
Quote:
|
Originally Posted by niterydr
We already did this once for the 3s.
|
Did you run any CFD simulations on your endtanks?
Quote:
|
Originally Posted by niterydr
Intercooler endtank design plays a VERY IMPORTANT roll in the cooling efficency and flow of your intercooler system.
|
http://www.dvdtfab.com/intercoolertestlab.pdf
On a side note, the textbook that Albert got many of his images out of for that report was written by a group of Iowa State professors.
Quote:
|
Originally Posted by tim
I agree, but I am also pretty sure that they would sell you the endtanks if you really wanted. I dont think it would be too hard to make them fit on a smaller(width) core and put it in a 1g.
|
When I get the cash, I am going to approach Albert about prototyping a kit for my Laser.