Log in

View Full Version : For the transmission GURU's


Pages : 1 [2]

TGPilot
08-31-2005, 02:02 PM
That is exactly what my welding buddy said...if it was small no biggy, drill a hole at the end and weld it up. With it going up and around the case like that it would be way too much room for impurities to get in and try to clean them out to get a "sturdy" weld.

I appreciate everyone's input though!

Thanks again!
-Kenny

JET
08-31-2005, 02:26 PM
You will never get you bellhousing welded back together without getting your input shaft runout going to crap.
Do you know what runout is? The tranny case would have to spin for the runout to change. That case could be fixed, but that is up to you.