crazy studdering while Reving

[A//// Guy]

Try a new coil pack, but first try a good set of wires- stock NGK or taylors or something that is good. Wires can make a big difference.

Everyone needs to settle down geez...

[Pimpin Dsmstyle]

Electrical is anything but my thing. I dont have one nor would I know how to use one. Every coil is sparking, I just dont know if it is sparking right. I'm going to try and buy more new wires and plugs. The reasons these ones suck, is because the ends break off everytime you disconnect them from the coil pack and the spark plug. 2/4 are trashed.

[Pimpin Dsmstyle]

Well I took craigs ass hole advise and it got me in the right direction ;) Thanks fucker!

The problem is still not fixed but I have a good feeling I know what it is. Since I put in NICE wires, NEW plugs gapped at .031, and checked out the coil pack; I realized sparks PERFECT. So what does that tell me? I air or fuel.. So I popped the clips off the injectors and pulled them one by one while the car was running. This is what I got

#4 - almost killed car
#3 - almost killed car
#2 - almost killed car
#1 - no change in how it ran

The car was already running weird and getting horrible gas mileage prior to this "tune up". So its likely that the injector was starting to get clogged and it finally had its own.

Problem is, I just sold my 450s and dont have anymore. I could use some good help if anyone feels like turning some advice over. Im up for any ideas.

Thanks in advance!

[JET]

I'll check to see if I have a single 450 left. I won't break up a set if I just have sets left though.

[Pimpin Dsmstyle]

I'll check to see if I have a single 450 left. I won't break up a set if I just have sets left though.

Thanks anyways jet, Mike already got me covered. I am not putting it in tomorrow, I will post results like I was instructed.

[Pimpin Dsmstyle]

I installed a couple injectors in #1. No improvement. Its still not firing. We put #2 clip on #1 and it was firing, but obviously out of order.

How can I fix the sensor / electrical problem? Can I just splice a new clip that attatches to the injector in there?

[JET]

Yeah, be sure to solder it and shrink wrap it. You don't want to ghetto something up there where it is going to get wet a lot.

[Pimpin Dsmstyle]

Yeah, be sure to solder it and shrink wrap it. You don't want to ghetto something up there where it is going to get wet a lot.

im talking about the clip which nothing but electrical current goes through.

I guess its a bit more complicated. I guess I have to use a DVOM and find where the signal is being lost and cut / solder there. I really dont know how to use that DVOM meter but I have one I can use.

ERIC FUCKING METZGER COULD BE SOME HELP HERE. Too bad he's horrible at answering the phone. EDIT ;) * notice the sarcasim now?

[Jakey]

ERIC FUCKING METZGER COULD BE SOME HELP HERE. Too bad he's horrible at answering the phone.

I wouldn't answer the damn phone either for someone who acts like you.

[Pimpin Dsmstyle]

I wouldn't answer the damn phone either for someone who acts like you.

Are you kidding me? We treat eachother like this. Bah - So much for a tech thread. PPL just keep whoring it up.