Anyone ever tried using 2 SMICs???

[MustGoFaster]

yeah, I have one Dejon Tool SMIC and the other one is off a 1991 Talon TSi. No big deal, just thinkin and drinkin :cool:

Finish the thinking bofore you start the drinking. :eek: :rolleyes: :D Things tend to work better that way.

[At-Least-It's-An-Evo]

Sounds pretty ghettoooo.

[niterydr]

yeah no...gonna beat the horse on this one and again say very bad idea.

[TheBlizzard]

If there is no usefull information provided in this thread I am just going to delete this thread. I know its been done before with two of them welded together but like everyone said its pretty ghetto.

So if anybody has any usefull information then go ahead, if not then this thread is getting deleted.

CRAIG

[niterydr]

Well for the obvious reasons of 1) complication of routing
2) extreme pressure drop
3) a smic from a dsm in stock form sucks (1g's have huge pressure drop on the inlets/outlets, 2g's have less capicity).
But to answer, yes people have tried, and heard of it, and you ARE free to do whatever you like, but I would assume it is agreed on this board (which is tough to come by) that it is an overall bad idea.
Best of luck to you in your future drinking ventures/brainstorms. :D ;) :p

[phoenix4g63t]

OK, thread over.