Over Boosting? Need some help guys

[asshanson]

Imma run a 10cm t3 turbine hosing on my 16g. Then get a nice t3 manifold, with a provision for a external wastegate. Then get a flange for the o2 housing and weld an elbow on it and maybe do a v-band down pipe i have always wanted.

http://cdn.meme.am/instances/500x/59248559.jpg

Seriously, why not just port the wastegate hole?

[A//// Guy]

lolz! So complicated.

[goodhart]

Have fun with a 16g that lags like a 62mm with that housing.

[jeremy1375]

Troubleshooting guide:

1) Your waste gate is welded shut or stuck closed. The lever on the flapper may be slipping on the pin or whoever welded it used a different piece of metal and let flapper swing freely.

If 1 is not the case goto 2.

2) You didn't really disconnect the flapper. Disconnect it.

If 2 is not the case go back to 1.

[1990GSX]

Troubleshooting guide:

1) Your waste gate is welded shut or stuck closed. The lever on the flapper may be slipping on the pin or whoever welded it used a different piece of metal and let flapper swing freely.

If 1 is not the case goto 2.

2) You didn't really disconnect the flapper. Disconnect it.

If 2 is not the case go back to 1.

I concur... I really don't think you had it open. The gate is designed for the turbo. There's a difference between it creeping up to 30 and just spooling strait to 30. Sure you may have the one oddball wastegate thats wayyyyyy too small but I doubt it.

[TkrPerformance]

may be take some pictures of your set up and post them up.

[Halon]

"I see a T3 / TDO5 turbo Dominic..."