Over Boosting? Need some help guys

[turbotalon1g]

^Where the fuck are you reading this shit you come up with?

Well it worked for me just fine, I put in 28psi springs and it was rock solid.

[turbotalon1g]

^Where the fuck are you reading this shit you come up with?

Well it worked for me just fine, I put in 28psi springs and it was rock solid.

[talonsway]

^Where the fuck are you reading this shit you come up with?

Read it some where on tuners a while back


Bad boost gauge?

Im going to look at how that thing is hooked up. The previous owner installed it.

How a 16g could build 30psi with an open wategate flap blows my mind, unless either 1) your flap is welded shut and you don't know, or 2) you are running no exhaust and are giving it more air than any 16g in history. Most barely get over 30 with a basically forced shut flapper.

Doesn't make any sense to me either like at all. The flapper is not welded shut from what i know i can move it with ease. I do have a 3inch turbo back exhaust but it still doesn't make any sense to me. Im going to take it apart this weekend and look into getting some parts.

[Shane@DBPerformance]

If you go off the o2 housing, don't expect it to perfectly fix the boost creep, unless you make the hole in the turbo bigger and port it.

[talonsway]

whats a good manifold that's mitsu flanged and has a provision for a Ext. WG? All the ones I see on classifieds and on extreme psi are t3 flanged.

[turbotalon1g]

There is none.

[91talontsi]

Wouldnt the solution with the test he did be to port the hole behind the flapper until its close to the size of the flapper? probably a ebay or amazon 16g ive read you have to do this to eliminate the boost creep on them.

[goodhart]

If it's a Chinese 16g just get rid of the Damn thing, they are known garbage

[talonsway]

If it's a Chinese 16g just get rid of the Damn thing, they are known garbage

not an ebay piece of shit

Wouldnt the solution with the test he did be to port the hole behind the flapper until its close to the size of the flapper? probably a ebay or amazon 16g ive read you have to do this to eliminate the boost creep on them.

http://www.dsmtuners.com/threads/evo16g-34mm-flapper-%C2%93upgrade%C2%94.163103/

I could...... but i think imma take a different approach.


15134


Imma run a 10cm t3 turbine hosing on my 16g. Then get a nice t3 manifold, with a provision for a external wastegate. Then get a flange for the o2 housing and weld an elbow on it and maybe do a v-band down pipe i have always wanted.

[TkrPerformance]

you are way over thinking this for something so simple