MLS Head Gasket

[RS98GSX]

Hey guys.

If you read this thread http://www.mitsustyle.com/forums/showthread.php?t=31677&highlight=idle
Then you know what happened.... Anyway I got a Mitsu MLS 4 layer head gasket from MAP. My question is proper ways to seal it. I know all about decking both head and block, but some guys say to clean and lap the block. I also head some guys using copper spray, or using oil to seal, how does that work? What should I do.

[Kracka]

Install it against a clean and dry surface.

[RS98GSX]

ok so no need to machine or deck the head and block. Just make sure both sides are clean and dry?

[Kracka]

If they're out, it's a good idea to have them checked/machined to ensure they're flat.

[asshanson]

If your head warped when you blew the previous headgasket you should probably get it machined flat, or at least make sure it's flat with a good straight edge. Probably don't need to machine the block.

[RS98GSX]

The head is completly level. I checked it with a straight edge and a feeler gauge. And just the head is out from when I melted my valve.

[Goat Blower]

I put on a little copper spray, just for good measure, but yeah, clean surfaces and proper torque procedure.

[RS98GSX]

Thanks guys