Valvesprings Recomendation?

[Enes]

ok what about these? Ferrea Dual Valve Springs
if not them which one's would you recomend?

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...sspagename=WDVW (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=2474965111&category=33617&sspagename=WDVW)

[npaulseth]

I thought our stock springs were good till about 8500 rpms. What are you planning on running it to? Isn't shep still on the stock springs?

[Enes]

i don't think he is... and as far as i know the 2g stock springs are good till about 7500 - 8000

-E

[npaulseth]

okay, my bad. I haven't heard anything bad about Ferrea, but I know that comp cams springs makes a bad batch every now and then. A F-Body guy I know wrecked his built LS1 because of that.

[Shane@DBPerformance]

Ferrea are good stuff. If you want high quality or need to rev it to 9500+ then get the Ferreas. If you want slightly better than stock and plan on keeping it under 8500 then get the Crowers.

[Enes]

Eveywhere i found it is that Farrea i can get for $255 shiped and cheapest i found for Crowers was like $260 ...

should i just go with Farrea? or is that going to cause un needed stress on the head and the components?

-E

[At-Least-It's-An-Evo]

Maybe you're looking at the just the pricing of the springs for the $255, and when looking at the pricing of the Crowers, you get springs and retainers for that much. ($260).

[JET]

I think Cher is right. The Crowers are also much lighter and don't put as much force on the cam (less holding force, but easier on components). I went with Crower, but I won't be going over 8k (with 1mm oversized valves).

[Enes]

this is just in preparation for the new engine this upcoming winter.... ..

thanx for the information.. will most likely be going with crowers then.

-E

[Shane@DBPerformance]

Crower springs can be had for around $115. Their retainers are like $150. You can also get a kit with both. I ran their spring/retainer combo to 8500 almost daily when my old 2G.