PDA

View Full Version : beaterX project thread

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 [135] 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152
goodhart
05-11-2013, 11:45 PM
Do any locals have their injectors done at Ravenworks in Maple Grove?

Who you having do the flywheel?
scheides
05-12-2013, 12:05 AM
Yes they do but since other people have had issues with 1680's I wanted FIC to look them over :)

Dunno if I'm even going to bother machining the flywheel, clutch had some good meat left on it...again, I gotta look things over and figure out the rest of these details still...
goodhart
05-12-2013, 12:08 AM
time to bust out the caliper then and take some step height measurements. :)
scheides
05-12-2013, 12:25 AM
time to bust out the caliper then and take some step height measurements. :)

Nope :)
goodhart
05-12-2013, 12:26 AM
wat
scheides
05-12-2013, 08:18 AM
wat

Evos have flat flywheels :). No .610 step required.
goodhart
05-12-2013, 10:43 AM
lucky
turbotalon1g
05-12-2013, 11:53 AM
Goodhart I'm disappointed.
goodhart
05-12-2013, 12:51 PM
^That I didn't know that? Well, for what its worth I was shitfaced last night haha
evotuner
05-12-2013, 02:05 PM
Evos have flat flywheels :). No .610 step required.

newb question but WAT?