To who may have blown a tranny or scared they may blow one

[CarPsyco84]

Swifty likes to rattle all the bolts loose on his car...

[turbotalon1g]

^How do you do that when it never runs?

[santa]

^How are poly mounts so bullshitty?

I like this! Good luck with solid motor mounts.... There is a reason why they never put solid mounts in car's besides the vibration :D

[CarPsyco84]

^How do you do that when it never runs?

Well that's why they all were advocating the solid mounts.

[tpunx99GSX]

I dont know why any of the respected tranny rebuilders never tell anyone this, maybe for job security......... :)

It is very important to replace motor mounts when making good power, especially with our 15+ year older cars that have worn mounts.

It is a good idea to replace them with stiffer mounts as normal mounts or worn out mounts will cause engine shake, and when it shakes it releases and applies engine load on and off fast. This can cause gear chatter with high load! It like taking an air impact to your gears, not cool.

Just thought id share this to help our commnity a bit as it seems these tranny's can get the best of us!

At the same time too stiff of mounts can cause faster wear on parts. The engine needs to flex sometimes to make it easier on the drivetrain and other components. Too stiff of mounts like solid mounts can cause issues. The car i have now is running full poly mounts, i am not sure i would ever do full solid mounts unless it is a race car where i need every ounce of power to go directly to the drivetrain. However, i do agree with you in the respect that bad mounts especially front and rear can be horrible on the drivetrain and other components more than mounts that are too stiff.

[turboimports]

I have poly inserts in mine. Some vibration from stock of course, but holding up great.

[mdost03]

Using solid mounts here, no issues and I DD the car. NEED these mounts to be able to floor it in 1st-2nd gear.

[Kracka]

I had all 4 poly mounts on my DSM and it was stupid. On my Evo I have just a poly front motor mount and its perfect for a street car. Nice crisp shifts with very minimal vibrations at idle.

[1QUICK4]

I am poor so I use the 3M Gooped stockers

[tpunx99GSX]

Every time i have used full poly mounts i have never had issues with vibrations. Lucky i guess. I have heard a lot depends on the balace of the motor, Similar to when you remove your balance shafts.