My Recently Blown Up Shep Stage 3

[Alpha D]

Ive learned 3000RPM isnt no where near enough to go anywhere when launching. To scared to try anything higher. Once you guys totally have it figured out. Ill be a gimme pig trying the various techniques out.

[CarPsyco84]

Ive learned 3000RPM isnt no where near enough to go anywhere when launching. To scared to try anything higher. Once you guys totally have it figured out. Ill be a gimme pig trying the various techniques out.

What do you know about launching... You even have your license yet?

[tpunx99GSX]

Ill be a gimme pig trying the various techniques out.

its Guinea pig not Gimme pig.

[turbotalon1g]

Didn't know they had driver's ed. in middle school.

[sleepydsm]

Haha. With my last, untuned, 20G car I could spin all 4!

This car? Just drives away. For some reason I think the NLTS rev limiter hits at 6k and I bog out. Even when NLTS is off it still sucks? too stiff suspenion in rear? (Car doesnt squat at all) Pressure plate suckin a wang? Me not pedalin' well? blah

[CarPsyco84]

So does it bog out or just not rev over 6k then? heh I raced a 331 stroked mustang last night and found out that even 5500 on the 50 trim isn't enough rpm, dogged it bad. You tryed more rpm?

[santa]

I leave the line at 6000 rpm small slip and spin all 4 through 1st shift at 8500rpm, and grab 2nd hard, and spin some more.

[turbotalon1g]

I had to up my 2 step my 2 increments on link I think I'm still about 5500ish range. But I'm not big powa

[Alpha D]

What do you know about launching... You even have your license yet?

I tried it just the other day 5k was good. You would of been amazed. Didnt dare do it again due to your txt about one launch braking the rear end coming through lol

[sleepydsm]

I think what happens is I hit the launch control rev limiter. I think the MPH isn't high enough or low enough?