rod bearings

[travail]

well looks like I am putting in a new crank and main-rod bearing and piston ring. I saw that the #4 piston ring look bad so I just going to hone out all the cylinder's and put in new piston ring sent I have the piston out.

[Fran05]

Is that what this was about?

http://mitsustyle.com/forums/showthread.php?t=25800

Busted!!! ;)

[goodhart]

well looks like I am putting in a new crank and main-rod bearing and piston ring. I saw that the #4 piston ring look bad so I just going to hone out all the cylinder's and put in new piston ring sent I have the piston out.


I suggest having John Gosh do the work if you are comfortable pulling the motor out and dissasembling it yourself

[Goat Blower]

JG would be best, but that job is also pretty easy with a bottle hone and a drill.

[travail]

I am getting a 100mm EAGLE FORGED CRANKSHAFT. It the same one as I have and here are the pics of the rings you can see little marks on them.
http://i259.photobucket.com/albums/hh306/travaille/102_3458.jpg
http://i259.photobucket.com/albums/hh306/travaille/102_3454.jpg

[Super Bleeder!!]

Eagle cranks for mitsus are junk. Ask MAP about them.

[Halon]

If you get an eagle crank, expect that it will need machining out of the box. They usually have a big ol' tag on them right out of the box saying so.

And FWIW, I have only ran King bearings. And so far so good.