PDA

View Full Version : wont start


Pages : 1 2 [3] 4 5 6

Powers
09-15-2009, 03:18 PM
umm probably just have to rent one and figure out how to do it myself. i have not put the exhaust on so there is no o2 sensors hooked up would that do anything?

deadeye
09-15-2009, 04:15 PM
It shouldn't make it not start. It will just run like crap when it does. If your in doubt plug em in and see if it helps.

The code reader is cake. All you gotta do is push a button and it does the rest for you. Thats gonna be your best bet at this point.

twack
09-15-2009, 04:25 PM
with a nice downpayment autozone might rent theirs

Constant_Project21
09-15-2009, 04:26 PM
My o2 sensor is non existant at the moment and my car runs fine. Don't think that would cause a no start.

Powers
09-15-2009, 04:35 PM
ok i didnt think it would really do anything like not make it fire at all

95talonracer
09-15-2009, 06:36 PM
Check and make sure the ground wire is connected that plugs together by the thermostat housing. It is a single black wire with i think a yellow stripe and it plugs into another single wire of the same. I forgot to do that and it had nothing.

EclipseGST
09-15-2009, 06:38 PM
Hmm... You replaced the cam sensor behind the intake cam? Did you make sure to put the correct cam gear back on after you did this? No reason to take the exhaust cam off but could the intake cam have gotten switched with a different one or even the exhaust cam if both gears were taking off?

Powers
09-15-2009, 10:25 PM
They are in the correct possition I had them marked

EclipseGST
09-15-2009, 10:31 PM
Where is the car located? Did Twack swap the motor or just do the timing?

Powers
09-15-2009, 10:51 PM
Car is by Mankato and be helped bolt it in but me and a friend hooked everything up so honestly I'm sure it's some hooked up wrong or not at all