FDSM Dyno Results...Finally lol

[Goat Blower]

I would look elsewhere besides Crower for cams. FP sounds like the e-ticket right now. I haven't heard much about their cams for the strokers above the FP3x though.

[95talonracer]

Very nice guys. So when are we going to see the updated numbers after your further tuning and cam swap or whatever you are planning on changing? Glad to see that the issue you were having was worked out.

[niterydr]

Nice numbers! Especially through an auto. I wonder why it nosedives so hard at 7300 rpm though? I can't think of any bottlenecks from looking at the setup unless your cams aren't keeping up. I'm guessing there's a lot more in it.

From what I remember, unless the vehicle dynamics changed with the firmware update, aka an ignition sync change...the ve of the engine tanks at higher rpm.

Cams my friends, the cams!

:)

[v8klla]

Yeah a cam change is definitely in order!

[AwdGSX13]

thats sweet, that beast is putting down some good power!

[tim]

That is badass. Sounds just wicked.

What are you going to do for a rear end?

[v8klla]

Ford 9" already in the works ;)

[AwdGSX13]

Well at least you'll know you will never have to go with a different rear end after that! 9" will be able to hold plenty of power in that beast!