clutch issues

[AwdGSX13]

yeah.. my trans has 180xxx rounds on it and its still going on strong!

[AwdGSX13]

ok so im still having some problems... i put a new clutch kit in just this last weekend after finding out the friction disk was destroyed.. (clutch,pressure plate and throw-out bearing) I also installed a new master cylinder in which i bench bled first, then proceeded to bleed it another time after installation at both points(the master and the slave). Yet i still do not have any pedal pressure and it still wont go in gear? Could it be the slave or am I having other problems?

[johnson]

how is your shift linkage?
does the slave cylinder push out when clutch pedal is depressed?
maybe your throw out bearing wasnt installed correctly?
did you check out the fork? long shot....


***maybe you need to adjust clutch pedal???

[JET]

Yeah, first thing to look as is if the slave is moving about 3/4". If it is, then the TOB might not be installed correctly.

[Andrew7dg]

better write this down, cheap clutches dont work.

Sig material
:23: